New HC-SR501 Infrared PIR Motion Sensor Module For Arduino Raspberry_fi

• Popularity - 17 views, 2.4 views per day, 7 days on eBay. Super high amount of views. 0 sold.
• Price - Avg: $0.00, Low: $0.00, High: $0.00. Best quality when compared to PicClick similar items.
• Seller - + items sold. 0% negative feedback. Great seller with very good positive feedback and over 50 ratings.

Description:<br>It is great for microcontrollers such as arduino for funduino and many more including the rasberry pi!<br>It is a HC--SR501 Sensor Module with an operating voltage of 5v to 20v.<br>Operating voltage. It has a high value of 3.3 volts and a low of 0 (it is either on or off). It's delay time can be adjusted from 5 to 200seconds as well as the sensing range from 3meter to 7meters. The entire sensor with the board is 32mm by 24mm (standard pir motion sensor). The sensor either gives off a 3.3volt high value when motion is detected and then resumes or continues to give off a 0 voltage when no motion is detected. If you use an arduino or other micro controllers you can use the 3.3 volt out to power the sensor or use the 5 volt power pin (vcc) to power the sensor. Either one will work.<br>Specification：<br>Working voltage range: DC 4.8-20V<br>Static current: <50uA<br>High level output: 3.3 V / low 0V<br>Trigger mode: L unrepeatable trigger /H repeated trigger (Default Repeating trigger)<br>Delay time: 0.5-200S (adjustable) can be produced range 0.1 seconds to a few minutes.<br>Blocking time: 2.5S (the default) can be produced range 0.1 seconds to tens of seconds.<br>Size: approx. 32mm*24mm circuit board<br>Induction angle: <100 degree cone angle<br>Working temperature: -15-+70 degrees<br>Induction of lens size: diameter: 23mm (default)<br>Note:<br>Please be reminded that due to lighting effects and monitor's brightness/contrast settings etc, the color tone of the photo and the actual item could be slightly different.<br>Package Included:<br>1pc New HC-SR501 Infrared PIR Motion Sensor Module<br>On Jul-17-21 at 09:40:08 PDT, seller added the following information:<br>